Modular Mixing Systems

This modular heavy-duty mixer system allows you the flexibility to create the best system for your mixing applications. System components are sold separately so you can tailor your system to meet your mixing needs. Simply start with a solid-state speed controller, add one of the two mixing heads depending on your speed and torque requirements, then select a shaft and propeller depending on your vessel and fluid.

Speed Controller
This solid-state controller offers precise speed control with a 100:1 adjustment range. A separate “forward/off/reverse” switch works independently from the speed control dial, allowing you to repeat mixer speed settings from one run to the next. An LED indicates when power is on. Motor speed is maintained within 10% despite changes in line power or torque load conditions. Speed stability is critical for materials that change viscosity as mixing progresses.
Remote controller is connected to the mixer head via a 6-ft. three wire cord which keeps electronics away from hazardous spills or splashes. Dimensions are 7 W x 3 3/16 H x 4 7/8”D. Includes 6-ft. power cord with grounded plug. 115 volt. To be used with mixer heads 802-330-10 and 802-330-12 only. Warranty: 2 years.

Mixer Heads
These rugged mixer heads feature TENV, permanent magnet DC motors with permanently lubricated ball bearing construction. All mixer heads are equipped with an integral adjustable-tilt mounting assembly which permits the rotation of the mixer head from 0° to 30° for proper placement of shaft and propeller. Heads measure approximately 11.5”H x 3.625” dia. Supplied with appropriate chuck and 6-ft. three-wire cord with grounded plug. Order shafts, propellers and accessories separately. 115 volt.

The general purpose low speed, high-torque mixer head has a speed range of 9 to 900 rpm with 1/15 hp PMDC gear motor. Maximum torque is 70 in-oz. Includes Jacobs type chuck that accepts mixing shafts up to 3/8” dia.

The high speed, low-torque model incorporates a hollow through shaft and a precision, stainless steel hand-tightened collet. Through shaft design lets you position the propeller at any depth within the container, without moving the mixer head. This design also minimizes shaft “wobble” at higher speeds or with longer shaft lengths. Speed range is 23 to 2300 rpm with 1/10 hp PMDC motor. Maximum torque is 45 in-oz. Accepts 3/8” dia. shafts only.